linercommunications.blogg.se - Instacal not finding usb

#Instacal not finding usb install#

Click Install ACQ7700 Time Sync Service.If not, use Windows Explorer to run Install.exe. Insert the Ponemah Service Pack installation the PC’s CD drive.Click Sync card drivers from the installation splash screen.Wait for installation to complete and click Finish.

If prompted to stop any services prior to the start of installation, allow to automatically close and click Next.

Follow the onscreen instructions to progress through the install using the default values.

Note: The DSI 7700 Time Sync Service will be installed during this process.

Insert the Ponemah installation USB drive into an open USB port on the PC.

If the updated service is installed on a Ponemah v5.20-SP9+ system, then InstaCal v6.60 must also be used. However, with v5.3x an updated Sync Service is used to provide more detailed sync messages to the system, which requires the updated InstaCal v6.60.

When the Ponemah v5.20-SP9+ install includes InstaCal v6.26 the system will work as intended using this version.

If the previous version of Measurement Computing InstaCal is installed, it must be uninstalled prior installing the newer InstalCal v6.60, which is included with the Ponemah v5.3x install.

Please make sure that you do not install the PCI Board until after the Measurement Computing Software is installed from the Service Pack Installation CD. If you do not have a previous version of the Measurement Computing software installed, please follow all the steps below in order.The following steps outline the installation and setup of the Data Synchronization Card using Ponemah v5.20-SP9+ and Ponemah v5.3x. This board is also only supported with Ponemah v5.20 through v5.20-SP7.1 (i.e. Note: The CTR05 board (DSI PN: P02369) has been discontinued by the manufacturer and is no longer available. Windows® 7 SP1, or Windows® 10, 64-bit only.PhysioTel Digital Implants using Communication Link Controller (CLC) the ACQ-7700.PhysioTel or PhysioTel HD Implants using the Matrix 2.0 (MX2) and the ACQ-7700.The Measurement Computing PCI Quad04 board provides time synchronization data acquisition between DSI’s different acquisition hardware.